A quick reference to the gestures that aren't obvious from the buttons.
EQ graph
| Gesture | Effect |
|---|---|
| Drag a node left/right | Change the band's frequency |
| Drag a node up/down | Change the band's gain |
| Double-click a node | Reset that band to default |
| Shift-click a node | Reset that band to default |
| Hover a node | Show its Band number, Q, Freq and Gain |
To change a band's Q (width), use the band's control block below the graph. The EQ graph is covered in Chapter 7 — Shaping sound.
Gain card
| Gesture | Effect |
|---|---|
| Click − / + | Step the gain by 0.1 dB |
| Press and hold − / + | Glide the gain in 0.1 dB steps |
Delay card
| Gesture | Effect |
|---|---|
| Click the unit button | Cycle units: ms → m → samples → cm → in → ft |
| Click − / + | Step the delay by one step of the shown unit (see Appendix A — Reference tables) |
| Press and hold − / + | Glide the delay in those same steps |
| Click Reset | Set delay to 0 |
Measurement offsets
| Gesture | Effect |
|---|---|
| + / − on Delay | Step by 0.5 ms |
| Shift + + / − on Delay/Gain | Fine step (0.025×) |
| + / − on Gain | Step by 0.5 dB |
| ↩︎ reset | Zero that offset |
Measurement offsets are covered in Chapter 8 — Measuring your system.
General
| Gesture | Effect |
|---|---|
| Click an output in the sidebar | Select it; click again to deselect |
| Click a snapshot's colour dot | Show/hide it on the chart |
| Click a snapshot's name | Select it; click again to deselect |
| Click a channel chip on results | Focus that channel; click again for all |
| Hover any chart | Read Freq / Gain / Phase / Confidence at the cursor |
| Hover a diagnostics card | Shade that card's frequency band on the chart |
Note
All value fields accept a typed number as well as the +/− steppers, and values are clamped to the limits in Appendix A — Reference tables.
